The element size should be chosen in such fashion, that under the given load, the maximum allowed operational pressure of 5 to 6 bar is not exceeded. The overlaying maximum dynamic load should also not transgress the maximum allowed operational load. Best isolation grades are achieved, if over-dimensioning is avoided.

Including screw DIN 933/ISO 4017, large nut DIN 934 and small washer DIN 125/ISO 7089 for fastening the air-cushion vibration damper to the machine.

By default, the air-cushion vibration dampers FLN are supplied in a pressure-less state. After mounting, height H is adjusted by administering compressed air, with a maximum of 5 bar respectively 6 bar, in a range of +/- 5 mm respectively +/- 6 mm.

Prior to de-loading, the element must be completey de-ventilated.

To be noted: for the air-cushion dampers of the series FLN, it is compulsory to fasten them to the to-be-isolated machine via the included mounting screw DIN 933 ( refer to assembly instruction ).

In addition, we would like to recommend the general application of the optional mounting plates, for a full-faced covering of the air-cushion dampers. This facilitates protection against sinking-in, should a loss of pressur occur.